REAR WIPER MOTOR INSTALLATION

PROCEDURE


  1. INSTALL REAR WIPER MOTOR ASSEMBLY


    1. Install the rear wiper motor assembly with the 3 bolts.

      Torque:
      5.5 N*m  { 56 kgf*cm, 49 in.*lbf }

    2. Connect the connector.

  2. INSTALL REAR WIPER MOTOR GROMMET


    1. A004VS3E01
      Text in Illustration
      *1 MP Grease

      Apply MP grease to the entire surface of the rear wiper motor grommet lip.

      Tech Tips

      Make sure that the hole does not get clogged with grease and the grooves on the lip are filled with grease.

    2. A004ZUPE02
      Text in Illustration
      *1 Alignment Mark

      Install the rear wiper motor grommet.

      Tech Tips

      Install the grommet with its alignment mark facing up.

  3. INSTALL REAR WIPER ARM AND BLADE ASSEMBLY


    1. Operate the wiper and stop the windshield wiper motor at the automatic stop position.

    2. When reusing the rear wiper arm and blade assembly:


      1. A00500CE01
        Text in Illustration
        *1 Wiper Arm Serrations

        Clean the wiper arm serrations.

    3. When reusing the rear wiper motor assembly:


      1. A004X3FE01
        Text in Illustration
        *1 Wiper Pivot Serrations

        Clean the wiper pivot serrations with a wire brush.

    4. A0050AJ

      Temporarily install the rear wiper arm and blade assembly.

    5. A004ZGYE01
      Text in Illustration
      *1 Ceramic Dot

      Install the rear wiper arm and blade assembly with the nut to the position as shown in the illustration.

      Torque:
      5.5 N*m  { 56 kgf*cm, 49 in.*lbf }

      Tech Tips

      Hold the wiper arm by hand while tightening the nut.

    6. Turn the power switch on (IG).

    7. Operate the rear wiper while spraying washer fluid onto the back door glass. Make sure that the rear wiper functions properly and the wiper does not come into contact with the vehicle body.

    8. Lift the wiper arm twice after the wiper stops and check the wiper set position.

    9. Turn the power switch off.

  4. INSTALL REAR WIPER ARM HEAD CAP


    1. A004W3HE02

      Engage the 2 claws (B) to the rear wiper arm and blade assembly.

    2. Engage the 2 claws (A) to install the rear wiper arm head cap as shown in the illustration.

  5. INSTALL BACK DOOR TRIM BOARD ASSEMBLY

    Click here

  6. INSTALL BACK DOOR SIDE GARNISH LH

    Click here

  7. INSTALL BACK DOOR SIDE GARNISH RH

    Click here

  8. INSTALL UPPER BACK DOOR TRIM PANEL ASSEMBLY

    Click here