HOOD LOCK CONTROL CABLE ASSEMBLY INSTALLATION

PROCEDURE


  1. INSTALL HOOD LOCK CONTROL CABLE ASSEMBLY (for LHD)


    1. Pass the hood lock control cable assembly into the engine compartment.

    2. Pass the cable through the upper radiator support.

    3. Engage each clamp.

  2. INSTALL HOOD LOCK CONTROL CABLE ASSEMBLY (for RHD)


    1. Pass the hood lock control cable assembly into the engine compartment.

    2. Pass the cable through the upper radiator support.

    3. Engage each clamp.

  3. INSTALL HOOD LOCK ASSEMBLY (w/o Engine Hood Courtesy Switch)


    1. B001L0P

      Apply MP grease to the sliding areas of the lock.

    2. Connect the hood lock control cable.

    3. Install the hood lock assembly with the 2 bolts and hood lock bolt.

      Torque:
      8.0 N*m  { 82 kgf*cm, 71 in.*lbf }

    4. Install a new hood lock nut cap.

  4. INSTALL HOOD LOCK ASSEMBLY (w/ Engine Hood Courtesy Switch)


    1. B001LCT

      Apply MP grease to the sliding areas of the lock.

    2. Connect the hood lock control cable.

    3. Install the hood lock assembly with the 2 bolts and hood lock bolt.

      Torque:
      8.0 N*m  { 82 kgf*cm, 71 in.*lbf }

    4. Install a new hood lock nut cap.

    5. Engage the clamp.

    6. Connect the connector.

  5. INSTALL HOOD LOCK CONTROL LEVER SUB-ASSEMBLY


    1. Connect the hood lock control cable assembly and install the hood lock control lever sub-assembly.

  6. CONNECT HOOD LOCK CONTROL LEVER SUB-ASSEMBLY

    Click here

  7. INSTALL NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY (for LHD)

    Click here

  8. INSTALL COWL SIDE TRIM SUB-ASSEMBLY LH (for LHD)

    Click here

  9. INSTALL FRONT DOOR SCUFF PLATE LH (for LHD)

    Click here

  10. INSTALL NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY (for RHD)

    Click here

  11. INSTALL COWL SIDE TRIM SUB-ASSEMBLY RH (for RHD)

    Tech Tips

    Use the same procedure for the RH side and LH side Click here.

  12. INSTALL FRONT DOOR SCUFF PLATE RH (for RHD)

    Tech Tips

    Use the same procedure for the RH side and LH side Click here.

  13. INSTALL FRONT FENDER LINER LH (for LHD)

    Tech Tips

    Use the same procedure for the RH side and LH side Click here.

  14. INSTALL FRONT WHEEL LH (for LHD)

    Torque:
    103 N*m  { 1050 kgf*cm, 76 ft.*lbf }

  15. INSTALL FRONT FENDER LINER RH (for RHD)

    Click here

  16. INSTALL FRONT WHEEL RH (for RHD)

    Torque:
    103 N*m  { 1050 kgf*cm, 76 ft.*lbf }

  17. INSTALL MILLIMETER WAVE RADAR SENSOR ASSEMBLY (w/ Dynamic Radar Cruise Control System)

    Click here

  18. INSTALL FRONT BUMPER ASSEMBLY

    Click here

  19. ADJUST MILLIMETER WAVE RADAR SENSOR ASSEMBLY (w/ Dynamic Radar Cruise Control System)

    Click here

  20. INSPECT HOOD SUB-ASSEMBLY

    Click here

  21. ADJUST HOOD SUB-ASSEMBLY

    Click here