SLIDING ROOF SWITCH ASSEMBLY INSPECTION

PROCEDURE


  1. INSPECT SLIDING ROOF SWITCH (MAP LIGHT ASSEMBLY)


    1. B001KG5E01
      Text in Illustration
      *a

      Component without harness connected

      (Sliding Roof Switch (Map Light Assembly))

      Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      25 (DOWN) - 3 (GND3) TILT DOWN switch is pressed Below 1 Ω
      25 (DOWN) - 3 (GND3) TILT DOWN switch is not pressed 10 kΩ or higher
      24 (UP) - 3 (GND3) TILT UP switch is pressed Below 1 Ω
      24 (UP) - 3 (GND3) TILT UP switch is not pressed 10 kΩ or higher
      28 (CLS) - 3 (GND3) SLIDE CLOSE switch is pressed Below 1 Ω
      28 (CLS) - 3 (GND3) SLIDE CLOSE switch is not pressed 10 kΩ or higher
      27 (OPN) - 3 (GND3) SLIDE OPEN switch is pressed Below 1 Ω
      27 (OPN) - 3 (GND3) SLIDE OPEN switch is not pressed 10 kΩ or higher

      If the result is not as specified, replace the sliding roof switch (map light assembly).