ROOF HEADLINING DISASSEMBLY

PROCEDURE


  1. REMOVE NO. 2 ANTENNA CORD SUB-ASSEMBLY

    Click here

  2. REMOVE VANITY LIGHT ASSEMBLY

    Tech Tips

    Use the same procedure for the other vanity light.

    Click here

  3. REMOVE NO. 1 ROOF SILENCER PAD (w/o Sliding Roof)


    1. Remove the No. 1 roof silencer pad from the roof headlining assembly.

      B001N9L

  4. REMOVE NO. 3 ROOF SILENCER PAD (w/o Sliding Roof)


    1. Remove the No. 3 roof silencer pad from the roof headlining assembly.

      B001MQJ

  5. REMOVE NO. 4 ROOF SILENCER PAD (w/o Sliding Roof)


    1. Remove the No. 4 roof silencer pad from the roof headlining assembly.

      B001KRK

  6. REMOVE NO. 2 ROOF SILENCER PAD (w/o Sliding Roof)


    1. Remove the 2 No. 2 roof silencer pads from the roof headlining assembly.

      B001KVL

  7. REMOVE NO. 2 ROOF SILENCER PAD (w/ Sliding Roof)


    1. Remove the No. 2 roof silencer pad from the roof headlining assembly.

      B001LKI

  8. REMOVE NO. 1 ROOF WIRE (for LHD)


    1. Remove the adhesive tape from the roof headlining assembly.

      B001MKRC01
      *A w/o Sliding Roof *B w/ Sliding Roof
      *C w/o Pre-collision System *D w/ Pre-collision System
      *E w/ Rain Sensor *F w/ EC Mirror
      *G w/ Humidity Sensor - -
      B001MUK Adhesive Tape - -

    2. Turn the visor connectors counterclockwise approximately 90° and separate the connectors and each clamp from the roof headlining assembly.

      B001KRIC01
      *A w/o Sliding Roof *B w/ Sliding Roof
      *C w/o Pre-collision System *D w/ Pre-collision System
      *E w/ Rain Sensor *F w/ EC Mirror
      *G w/ Humidity Sensor - -
      *a 90° - -

    3. Remove the No. 1 roof wire from the roof headlining assembly.

  9. REMOVE NO. 1 ROOF WIRE (for RHD)


    1. Remove the adhesive tape from the roof headlining assembly.

      B001KU0C01
      *A w/o Sliding Roof *B w/ Sliding Roof
      *C w/o Pre-collision System *D w/ Pre-collision System
      *E w/ Humidity Sensor *F w/ EC Mirror
      *G w/ Rain Sensor - -
      B001MUK Adhesive Tape - -

    2. Turn the visor connectors counterclockwise approximately 90° and separate the connectors and each clamp from the roof headlining assembly.

      B001LNWC01
      *A w/o Sliding Roof *B w/ Sliding Roof
      *C w/o Pre-collision System *D w/ Pre-collision System
      *E w/ Rain Sensor *F w/ EC Mirror
      *G w/ Humidity Sensor - -
      *a 90° - -

    3. Remove the No. 1 roof wire from the roof headlining assembly.