CONDENSER REASSEMBLY

PROCEDURE

1. INSTALL COOLER DRYER

   
   

   1. 

      Using pliers, install a new cooler dryer to the modulator.

   2. for Type A:

      
      

      1. 

         Apply a sufficient amount of compressor oil to the O-ring and the fitting surfaces of a new cap.

         Compressor oil
         ND-OIL 11 or equivalent

   3. for Type B:

      
      

      1. 

         Apply a sufficient amount of compressor oil to the 3 O-rings and the fitting surfaces of a new cap.

         Compressor oil
         ND-OIL 11 or equivalent

   4. 

      Text in Illustration

      *1	14 mm Straight Hexagon Wrench

      Using a 14 mm straight hexagon wrench, install the cap to the cooler condenser core.

      Torque:

      for Type A

      2.9 N*m  { 30 kgf*cm, 26 in.*lbf }

      for Type B

      4.0 N*m  { 41 kgf*cm, 35 in.*lbf }

      Note

      
      

      • Keep the O-ring and O-ring fitting surfaces clean from dirt or any foreign matter.

      • Do not use any compressor oil other than ND-OIL 11 or equivalent. If any compressor oil other than ND-OIL 11 or equivalent is used, compressor motor insulation performance may decrease, resulting in a leakage of electric power.

2. INSTALL COOLER CONDENSER CUSHION

   
   

   1. for LH Side:

      
      

      1. 

         Install the cooler condenser cushion.

   2. for RH Side:

      
      

      1. 

         Install the cooler condenser cushion.