FRONT SEAT OUTER BELT ASSEMBLY REMOVAL

PROCEDURE


  1. PRECAUTION

    Note

    After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notice before proceeding with work Click here.

  2. REMOVE REAR NO. 2 FLOOR BOARD

    Click here

  3. REMOVE REAR DECK FLOOR BOX

    Click here

  4. REMOVE REAR NO. 3 FLOOR BOARD

    Click here

  5. REMOVE DECK FLOOR BOX RH

    Click here

  6. REMOVE REAR FLOOR BOARD UPPER NO. 3 PLATE

    Click here

  7. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    CAUTION:

    Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  8. REMOVE FRONT DOOR SCUFF PLATE

    Click here

  9. REMOVE NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY (for RHD)

    Click here

  10. REMOVE COWL SIDE TRIM SUB-ASSEMBLY

    Click here

  11. REMOVE FRONT DOOR OPENING TRIM WEATHERSTRIP

    Click here

  12. REMOVE REAR DOOR SCUFF PLATE

    Click here

  13. REMOVE REAR DOOR OPENING TRIM WEATHERSTRIP

    Click here

  14. REMOVE LAP BELT OUTER ANCHOR COVER


    1. B001KRD

      Disengage the 3 claws and remove the lap belt outer anchor cover.

  15. DISCONNECT FRONT SEAT OUTER BELT ASSEMBLY


    1. B001LZC

      Remove the bolt and disconnect the floor end of the front seat outer belt assembly.

  16. REMOVE CENTER PILLAR LOWER GARNISH

    Click here

  17. REMOVE CENTER PILLAR UPPER GARNISH

    Click here

  18. REMOVE FRONT SEAT OUTER BELT ASSEMBLY


    1. B001KNX

      Remove the nut and disconnect the shoulder anchor of the front seat outer belt assembly.

    2. B001KGEE02
      Text in Illustration
      *A w/ Pre-crash Safety System
      *1 Pretensioner Connector

      Using a screwdriver, pull out the locking button in the direction shown by the arrow in the illustration to release the lock, and disconnect the pretensioner connector as shown in the illustration.

      Tech Tips

      Tape the screwdriver tip before use.

    3. Disconnect the connector.

    4. w/ Pre-crash Safety System:


      1. Disconnect the connector.

    5. B001MMZ

      Remove the 2 bolts and front seat outer belt assembly.

  19. REMOVE FRONT SHOULDER BELT ANCHOR ADJUSTER ASSEMBLY


    1. B001MRM

      Remove the 2 bolts.

    2. Disengage the guide and remove the front shoulder belt anchor adjuster assembly.