FRONT SEAT ASSEMBLY(for Manual Seat) INSTALLATION

PROCEDURE


  1. INSTALL FRONT SEAT ASSEMBLY


    1. Place the front seat assembly in the cabin.

      Note

      Be careful not to damage the vehicle body.

    2. Connect each connector and clamp under the seat.

    3. Temporarily install the front seat assembly with the 4 bolts.

    4. Lift up the seat track adjusting handle and move the seat to the rearmost position.

    5. B001N54E01

      Tighten the 2 bolts on the front side of the seat.

      Torque:
      37 N*m  { 375 kgf*cm, 27 ft.*lbf }

      Tech Tips

      Tighten the bolts in the order indicated in the illustration.

    6. Lift up the seat track adjusting handle and move the seat to the foremost position.

    7. B001LOUE01

      Tighten the 2 bolts on the rear side of the seat.

      Torque:
      37 N*m  { 375 kgf*cm, 27 ft.*lbf }

      Tech Tips

      Tighten the bolts in the order indicated in the illustration.

  2. INSPECT SEAT SLIDE ADJUSTER LOCKS


    1. During the sliding operation of the front seat, check that the left and right adjusters move together smoothly and lock simultaneously. If the seat adjusters do not lock simultaneously, loosen the seat installation bolts to adjust the adjuster position.

  3. INSTALL REAR INNER SEAT TRACK BRACKET COVER


    1. Lift up the seat track adjusting handle and move the seat to the foremost position.

    2. Engage the 2 claws to install the rear inner seat track bracket cover.

  4. INSTALL REAR OUTER SEAT TRACK BRACKET COVER


    1. Engage the 2 claws to install the rear outer seat track bracket cover.

  5. INSTALL FRONT INNER SEAT TRACK BRACKET COVER


    1. Lift up the seat track adjusting handle and move the seat to the rearmost position.

    2. Engage the 2 claws to install the front inner seat track bracket cover.

  6. INSTALL FRONT OUTER SEAT TRACK BRACKET COVER


    1. Engage the 2 claws to install the front outer seat track bracket cover.

  7. INSTALL FRONT SEAT HEADREST ASSEMBLY

  8. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here

  9. INSTALL REAR FLOOR BOARD UPPER NO. 3 PLATE

    Click here

  10. INSTALL DECK FLOOR BOX RH

    Click here

  11. INSTALL REAR NO. 3 FLOOR BOARD

    Click here

  12. INSTALL REAR DECK FLOOR BOX

    Click here

  13. INSTALL REAR NO. 2 FLOOR BOARD

    Click here

  14. INSPECT SRS WARNING LIGHT

    Click here