FRONT SEAT ASSEMBLY(for Manual Seat) REMOVAL

PROCEDURE


  1. PRECAUTION

    CAUTION:


    • Be sure to read Precaution thoroughly before servicing Click here.

    • If the side airbag was deployed, replace the front seat airbag assembly and separate type front seatback spring assembly with a new one.

    Note

    After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work Click here.

  2. REMOVE REAR NO. 2 FLOOR BOARD

    Click here

  3. REMOVE REAR DECK FLOOR BOX

    Click here

  4. REMOVE REAR NO. 3 FLOOR BOARD

    Click here

  5. REMOVE DECK FLOOR BOX RH

    Click here

  6. REMOVE REAR FLOOR BOARD UPPER NO. 3 PLATE

    Click here

  7. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    CAUTION:

    Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  8. REMOVE FRONT SEAT HEADREST ASSEMBLY

  9. REMOVE FRONT OUTER SEAT TRACK BRACKET COVER


    1. B001N7G

      Disengage the 2 claws and remove the front outer seat track bracket cover.

  10. REMOVE FRONT INNER SEAT TRACK BRACKET COVER


    1. B001MP9

      Disengage the 2 claws and remove the front inner seat track bracket cover.

  11. REMOVE REAR OUTER SEAT TRACK BRACKET COVER


    1. Lift up the seat track adjusting handle and move the seat to the foremost position.

    2. B001MWT

      Disengage the 2 claws and remove the rear outer seat track bracket cover.

  12. REMOVE REAR INNER SEAT TRACK BRACKET COVER


    1. B001KXL

      Disengage the 2 claws and remove the rear inner seat track bracket cover.

  13. REMOVE FRONT SEAT ASSEMBLY


    1. B001LOU

      Remove the 2 bolts on the rear side of the seat.

    2. Lift up the seat track adjusting handle and move the seat to the rearmost position.

    3. B001N54

      Remove the 2 bolts on the front side of the seat.

    4. Disconnect each connector and clamp under the seat.

    5. Lift up the seat track adjusting handle and move the seat to the center position. Also, operate the reclining adjuster release handle and move the seatback to the upright position.

    6. Remove the front seat assembly.

      Note

      Be careful not to damage the vehicle body.