SEAT BELT CONTROL ECU REMOVAL

PROCEDURE


  1. PRECAUTION

    Note

    After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notice before proceeding with work Click here.

  2. REMOVE REAR NO. 2 FLOOR BOARD

    Click here

  3. REMOVE REAR DECK FLOOR BOX

    Click here

  4. REMOVE REAR NO. 3 FLOOR BOARD

    Click here

  5. REMOVE DECK FLOOR BOX RH

    Click here

  6. REMOVE REAR FLOOR BOARD UPPER NO. 3 PLATE

    Click here

  7. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    CAUTION:

    Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  8. REMOVE NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY (for LHD)

    Click here

  9. REMOVE NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY (for RHD)

    Click here

  10. REMOVE FRONT DOOR SCUFF PLATE

    Tech Tips

    Use the same procedure for the RH side and LH side Click here.

  11. REMOVE COWL SIDE TRIM SUB-ASSEMBLY

    Tech Tips

    Use the same procedure for the RH side and LH side Click here.

  12. DISCONNECT FRONT DOOR OPENING TRIM WEATHERSTRIP

    Click here

  13. REMOVE INSTRUMENT SIDE PANEL

    Click here

  14. REMOVE LOWER NO. 2 INSTRUMENT PANEL AIRBAG ASSEMBLY

    Click here

  15. REMOVE GLOVE COMPARTMENT DOOR ASSEMBLY

    Click here

  16. REMOVE ECU INTEGRATION BOX RH (for LHD)

    Click here

  17. REMOVE ECU INTEGRATION BOX LH (for RHD)

    Click here

  18. REMOVE SEAT BELT CONTROL ECU (for LHD)


    1. A004YUY

      Disengage the 2 claws and remove the seat belt control ECU.

  19. REMOVE SEAT BELT CONTROL ECU (for RHD)


    1. A004YQW

      Disengage the 2 claws and remove the seat belt control ECU.