PRE-CRASH SAFETY SYSTEM, Diagnostic DTC:B2085

DTC Code DTC Name
B2085 Communication Error from Driving Support ECU to VSC ECU

DESCRIPTION

This DTC is stored when CAN communication between the driving support ECU and brake booster with master cylinder (skid control ECU) is interrupted.

This circuit consists of the driving support ECU, brake booster with master cylinder (skid control ECU) and seat belt control ECU. DTC B2085 is stored when the seat belt control ECU detects an interruption in CAN communication between the driving support ECU and brake booster with master cylinder (skid control ECU).

DTC No. DTC Detection Condition Trouble Area
B2085 The brake booster with master cylinder (skid control ECU) detects an interruption in CAN communication between the driving support ECU and brake booster with master cylinder (skid control ECU) for 1 second or more.

  • CAN communication system

  • Power management control ECU

  • Seat belt control ECU

  • Electronically controlled brake system

  • Driving support ECU

CAUTION / NOTICE / HINT

Tech Tips

This circuit uses CAN communication. Therefore, be sure to check that the CAN communication system is normal before performing inspection.

PROCEDURE


  1. CHECK DTC OUTPUT (CAN COMMUNICATION SYSTEM)


    1. Clear the DTCs Click here.

    2. Check for DTCs.

      OK
      CAN communication system DTC is not output.

    NG

    GO TO CAN COMMUNICATION SYSTEM Click here

    OK

  2. CHECK DTC OUTPUT (PRE-CRASH SAFETY SYSTEM)


    1. Using the intelligent tester, enter the following menus: Body / Pre-Crash / DTC.

    2. Clear the DTCs Click here.

    3. Check for DTCs.

      OK
      DTC B2085 is not output.

    OK

    CHECK FOR INTERMITTENT PROBLEMS (SYMPTOMS SIMULATION) Click here

    NG

    REPLACE SEAT BELT CONTROL ECU Click here