SEAT POSITION SENSOR REMOVAL

CAUTION / NOTICE / HINT

Note


  • Use the same procedure for the driver side of RHD and LHD vehicles.

  • The procedures listed below are for the driver side of an LHD vehicle.

PROCEDURE


  1. REMOVE FRONT SEAT ASSEMBLY LH

    for Manual Seat: Click here

    for Power Seat: Click here

  2. REMOVE RECLINING ADJUSTER RELEASE HANDLE LH (for Manual Seat)

    Click here

  3. REMOVE VERTICAL ADJUSTING HANDLE LH (for 6 Way Seat Type)

    Click here

  4. REMOVE FRONT SEAT CUSHION SHIELD LH (for Manual Seat)

    Click here

  5. REMOVE SEAT POSITION AIRBAG SENSOR (for Manual Seat)


    1. A004XR4

      Separate the wire harness from the 2 hooks.

    2. A004Y9M

      Disconnect the connector.

    3. Using a T30 "TORX" socket wrench, remove the "TORX" screw and seat position airbag sensor with the seat slide position sensor protector.

    4. A004W1D

      Remove the seat position airbag sensor from the seat slide position sensor protector as shown in the illustration.

  6. REMOVE SEAT POSITION AIRBAG SENSOR (for Power Seat)


    1. A004VD9

      Separate the wire harness from the 2 hooks.

    2. Disconnect the connector.

    3. A004WI1

      Using a T30 "TORX" socket wrench, remove the "TORX" screw, nut and seat position airbag sensor with the seat slide position sensor protector.

    4. A004W1D

      Remove the seat position airbag sensor from the seat slide position sensor protector as shown in the illustration.