CENTER AIRBAG SENSOR ASSEMBLY INSTALLATION

PROCEDURE


  1. INSTALL AIRBAG SENSOR ASSEMBLY


    1. Check that the power switch is off.

    2. Check that the cable is disconnected from the negative (-) auxiliary battery terminal.

      CAUTION:

      Wait at least 90 seconds after disconnecting the cable from the negative (-) auxiliary battery terminal to disable the SRS system.

    3. B001KC8E01
      Text in Illustration
      *1 Waterproof Sheet

      Install the airbag sensor assembly with the 3 bolts.

      Torque:
      18 N*m  { 178 kgf*cm, 13 ft.*lbf }

      Note


      • If the airbag sensor assembly has been dropped, or there are any cracks, dents or other defects in the case or connector, replace it with a new one.

      • When installing the airbag sensor assembly, be careful that the SRS wiring does not interfere with or is not pinched between other parts.

      • When the power switch is first turned on (IG) after the airbag sensor assembly has been replaced, make sure that no one is in the vehicle.

    4. B001KHK

      Connect the connectors to the airbag sensor assembly as shown in the illustration.

      Note

      When connecting any airbag connector, take care not to damage the airbag wire harness.

    5. Check that the waterproof sheet is properly set.

    6. Check that there is no looseness in the installation parts of the airbag sensor assembly.

  2. INSTALL CONSOLE BOX LH

    Click here

  3. INSTALL CONSOLE BOX INSERT

    Click here

  4. INSTALL CONSOLE BOX RH

    Click here

  5. INSTALL FRONT NO. 2 CONSOLE BOX INSERT

    Click here

  6. INSTALL INTEGRATION CONTROL AND PANEL ASSEMBLY

    Click here

  7. INSTALL SHIFT LEVER KNOB SUB-ASSEMBLY

    Click here

  8. INSTALL LOWER NO. 2 INSTRUMENT PANEL AIRBAG ASSEMBLY

    Click here

  9. INSTALL REAR CONSOLE BOX ASSEMBLY

    Click here