CENTER AIRBAG SENSOR ASSEMBLY REMOVAL

PROCEDURE


  1. REMOVE REAR CONSOLE BOX ASSEMBLY

    Click here

  2. REMOVE LOWER NO. 2 INSTRUMENT PANEL AIRBAG ASSEMBLY

    Click here

  3. REMOVE SHIFT LEVER KNOB SUB-ASSEMBLY

    Click here

  4. REMOVE INTEGRATION CONTROL AND PANEL ASSEMBLY

    Click here

  5. REMOVE CONSOLE BOX INSERT

    Click here

  6. REMOVE CONSOLE BOX LH

    Click here

  7. REMOVE FRONT NO. 2 CONSOLE BOX INSERT

    Click here

  8. REMOVE CONSOLE BOX RH

    Click here

  9. REMOVE AIRBAG SENSOR ASSEMBLY


    1. Check that the power switch is off.

    2. Check that the cable is disconnected from the negative (-) auxiliary battery terminal.

      CAUTION:

      Wait at least 90 seconds after disconnecting the cable from the negative (-) auxiliary battery terminal to disable the SRS system.

    3. B001NCY

      Disconnect the connectors from the airbag sensor assembly as shown in the illustration.

      Note

      When disconnecting any airbag connector, take care not to damage the airbag wire harness.

    4. B001KC8

      Remove the 3 bolts and airbag sensor assembly.