CURTAIN SHIELD AIRBAG ASSEMBLY INSTALLATION

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for the RH side and LH side.

  • The procedure listed below is for the LH side.

PROCEDURE


  1. INSTALL CURTAIN SHIELD AIRBAG ASSEMBLY


    1. Check that the power switch is off.

    2. Check that the cable is disconnected from the negative (-) auxiliary battery terminal.

      CAUTION:

      Wait at least 90 seconds after disconnecting the cable from the negative (-) auxiliary battery terminal to disable the SRS system.

    3. Temporarily install the curtain shield airbag assembly with the 5 hooks.

      Note

      Do not twist the curtain shield airbag assembly when installing it.

    4. Install 5 new bolts in the order shown in the illustration.

      B001KS0E03
      Torque:
      9.8 N*m  { 100 kgf*cm, 87 in.*lbf }

    5. Install the curtain shield airbag assembly to the body panel with 4 new clips and 4 new spacers in the order shown in the illustration

      B001KY7E03
      Text in Illustration
      *1 Pin *2 Clip
      *3 Airbag *4 Body
      *5 Spacer - -

    6. Install the 4 pins.

      Note

      Make sure that the pins of the clips are pushed in firmly.

    7. B001LUQ

      Connect the curtain shield airbag connector.

      Note

      When connecting any airbag connector, take care not to damage the airbag wire harness.

    8. Push in the lock to install the airbag connector.

  2. INSTALL ROOF HEADLINING ASSEMBLY

    Click here