FRONT PASSENGER AIRBAG ASSEMBLY REMOVAL

PROCEDURE


  1. PRECAUTION

    CAUTION:

    Be sure to read Precaution thoroughly before servicing Click here.

    Note

    After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work Click here.

  2. REMOVE MULTI-DISPLAY (w/ Navigation System)

    Click here

  3. DISCONNECT NO. 3 INSTRUMENT PANEL WIRE


    1. Check that the power switch is off.

    2. Check that the cable is disconnected from the negative (-) auxiliary battery terminal.

      CAUTION:

      Wait at least 90 seconds after disconnecting the cable from the negative (-) auxiliary battery terminal to disable the SRS system.

    3. B001NEPE01
      Text in Illustration
      *1 Slider

      Slide the slider to release the lock, and then disconnect the connector.

      Note

      When disconnecting any airbag connector, take care not to damage the airbag wire harness.

  4. REMOVE UPPER INSTRUMENT PANEL ASSEMBLY

    Click here

  5. REMOVE INSTRUMENT PANEL PASSENGER AIRBAG ASSEMBLY

    CAUTION:

    When storing the instrument panel passenger airbag assembly, keep the airbag deployment side facing upward.


    1. B001LRF

      Remove the 2 screws.

    2. B001MWIE03
      Text in Illustration
      *1 Protective Tape

      Using a screwdriver with the tip wrapped with protective tape, lean the instrument panel and disengage the 3 hooks as shown in the illustration.

      Note

      Do not damage the deployment surface of the instrument panel passenger airbag assembly.

    3. B001KYS

      Disengage the 3 hooks to remove the instrument panel passenger airbag assembly from the upper instrument panel assembly.

  6. REMOVE NO. 3 INSTRUMENT PANEL WIRE


    1. B001KJXE01
      Text in Illustration
      *1 Protective Tape

      Using a screwdriver with the tip wrapped with protective tape, release the 2 airbag connector locks.

    2. Disconnect the 2 airbag connectors to remove the No. 3 instrument panel wire from the instrument panel passenger airbag assembly.

      Note

      When disconnecting any airbag connector, take care not to damage the airbag wire harness.