CAUTION / NOTICE / HINT
Note
Use the same procedure for the front passenger side of RHD and LHD vehicles.
The procedures listed below are for the front passenger side of an LHD vehicle.
PROCEDURE
INSTALL LOWER NO. 2 INSTRUMENT PANEL AIRBAG ASSEMBLY
Check that the power switch is off.
Check that the cable is disconnected from the negative (-) auxiliary battery terminal.
CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) auxiliary battery terminal to disable the SRS system.
Connect the airbag connector to the lower No. 2 instrument panel airbag assembly.
Note
When connecting any airbag connector, take care not to damage the airbag wire harness.
Push in the lock to install the airbag connector.
Temporarily install the lower No. 2 instrument panel airbag assembly with the 6 claws and 2 guides.
Install the 3 bolts.
Note
Confirm that the lower No. 2 instrument panel airbag assembly is installed securely without any excessive gaps and is not protruding outward.
INSTALL COWL SIDE TRIM SUB-ASSEMBLY RH
Tech Tips
Use the same procedure for the RH side and LH side Click here.
INSTALL FRONT DOOR SCUFF PLATE RH
Tech Tips
Use the same procedure for the RH side and LH side Click here.
INSTALL NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY
for LHD: Click here
for RHD: Click here
INSTALL INSTRUMENT SIDE PANEL RH
INSTALL FRONT DOOR OPENING TRIM WEATHERSTRIP RH
CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL
Note
When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.
INSTALL REAR FLOOR BOARD UPPER NO. 3 PLATE
INSTALL DECK FLOOR BOX RH
INSTALL REAR NO. 3 FLOOR BOARD
INSTALL REAR DECK FLOOR BOX
INSTALL REAR NO. 2 FLOOR BOARD
PERFORM DIAGNOSTIC SYSTEM CHECK
INSPECT SRS WARNING LIGHT