KNEE AIRBAG ASSEMBLY(for Driver Side) INSTALLATION

PROCEDURE


  1. INSTALL LOWER NO. 1 INSTRUMENT PANEL AIRBAG ASSEMBLY


    1. Check that the power switch is off.

    2. Check that the cable is disconnected from the negative (-) auxiliary battery terminal.

      CAUTION:

      Wait at least 90 seconds after disconnecting the cable from the negative (-) auxiliary battery terminal to disable the SRS system.

    3. B001ND8

      Connect the airbag connector to the lower No. 1 instrument panel airbag assembly.

      Note

      When connecting any airbag connector, take care not to damage the airbag wire harness.

    4. Push in the lock to install the airbag connector.

    5. Temporarily install the lower No. 1 instrument panel airbag assembly with the 6 claws and 3 guides.

    6. Install the 4 bolts.

      Torque:
      10 N*m  { 102 kgf*cm, 7 ft.*lbf }

      Note

      Confirm that the lower No. 1 instrument panel airbag assembly is installed securely without any excessive gaps and is not protruding outward.

  2. INSTALL NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY

    for LHD: Click here

    for RHD: Click here

  3. CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  4. INSTALL REAR FLOOR BOARD UPPER NO. 3 PLATE

    Click here

  5. INSTALL DECK FLOOR BOX RH

    Click here

  6. INSTALL REAR NO. 3 FLOOR BOARD

    Click here

  7. INSTALL REAR DECK FLOOR BOX

    Click here

  8. INSTALL REAR NO. 2 FLOOR BOARD

    Click here

  9. PERFORM DIAGNOSTIC SYSTEM CHECK

    Click here

  10. INSPECT SRS WARNING LIGHT

    Click here