RELAY ON-VEHICLE INSPECTION

PROCEDURE


  1. INSPECT DOME CUT RELAY


    1. A004XSPE01
      Text in Illustration
      *a

      Component without harness connected

      (Dome Cut Relay)

      Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      3 - 5 Voltage is not applied between terminals 1 and 2 10 kΩ or higher
      3 - 5 Voltage is applied between terminals 1 and 2 Below 1 Ω

      If the result is not as specified, replace the DOME CUT relay.