GLOVE BOX LIGHT INSTALLATION

PROCEDURE

1. INSTALL GLOVE BOX LIGHT ASSEMBLY

   
   

   1. Engage the 2 claws to install the glove box light assembly.

2. INSTALL GLOVE COMPARTMENT DOOR ASSEMBLY

   Click here

3. INSTALL LOWER NO. 2 INSTRUMENT PANEL AIRBAG ASSEMBLY

   Click here

4. INSTALL NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY

   for LHD: Click here

   for RHD: Click here

5. INSTALL INSTRUMENT SIDE PANEL

   Click here

6. INSTALL FRONT DOOR OPENING TRIM WEATHERSTRIP

   for LHD: Click here

   for RHD: Click here

7. INSTALL COWL SIDE TRIM SUB-ASSEMBLY

   Tech Tips

   Use the same procedure for the RH side and LH side Click here.

8. INSTALL FRONT DOOR SCUFF PLATE

   Tech Tips

   Use the same procedure for the RH side and LH side Click here.

9. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

   Note

   When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

10. INSTALL REAR FLOOR BOARD UPPER NO. 3 PLATE

    Click here

11. INSTALL DECK FLOOR BOX RH

    Click here

12. INSTALL REAR NO. 3 FLOOR BOARD

    Click here

13. INSTALL REAR DECK FLOOR BOX

    Click here

14. INSTALL REAR NO. 2 FLOOR BOARD

    Click here

15. PERFORM DIAGNOSTIC SYSTEM CHECK

    Click here

16. INSPECT SRS WARNING LIGHT

    Click here