INTRUSION SENSOR REMOVAL

PROCEDURE


  1. REMOVE MAP LIGHT ASSEMBLY

    Click here

  2. REMOVE INTRUSION SENSOR (THEFT WARNING ULTRASONIC SENSOR) (w/o Sliding Roof)

    Note

    When replaced the intrusion sensor (theft warning ultrasonic sensor), eliminate static electricity by touching the vehicle body to prevent components from being damaged.


    1. w/ Microphone:


      1. A004W55

        Peel back the tape used to secure the cord only to the extent that allows removal of the cord.

        Tech Tips

        Tape is not available as a supply part. Try to leave as much tape as possible on the map light assembly so that the tape can be reused.

      2. A004WXU

        Disconnect the connector and disengage the clamp.

    2. A004XHO

      Peel back the tape used to secure the cord only to the extent that allows removal of the cord.

      Tech Tips

      Tape is not available as a supply part. Try to leave as much tape as possible on the map light assembly so that the tape can be reused.

    3. A004VZ7

      Remove the 2 screws and disconnect the connector.

    4. Disengage the 2 clamps.

    5. A004XLW

      Remove the 7 screws and cover.

    6. A004XQO

      Remove the board.

    7. A004YI6

      Remove the 4 screws and intrusion sensor (theft warning ultrasonic sensor) from the base.

  3. REMOVE INTRUSION SENSOR (THEFT WARNING ULTRASONIC SENSOR) (w/ Sliding Roof)

    Note

    When replaced the intrusion sensor (theft warning ultrasonic sensor), eliminate static electricity by touching the vehicle body to prevent components from being damaged.


    1. A004XBH

      Remove the 2 screws and disconnect the connector.

    2. A004Y1Q

      Disengage the 6 clamps.

    3. w/ Microphone:


      1. A004Y36

        Peel back the tape used to secure the cord only to the extent that allows removal of the cord.

        Tech Tips

        Tape is not available as a supply part. Try to leave as much tape as possible on the map light assembly so that the tape can be reused.

      2. A004Z6U

        Disconnect the connector and disengage the clamp.

    4. A004WIL

      Remove the 7 screws and cover.

    5. A004XQO

      Remove the board.

    6. A004YI6

      Remove the 4 screws and intrusion sensor (theft warning ultrasonic sensor) from the base.