FRONT DOOR LOCK INSTALLATION

PROCEDURE


  1. INSTALL FRONT DOOR LOCK ASSEMBLY

    Note


    • When reusing the removed front door lock assembly, replace the door lock wiring harness seal on the connector with a new one.

    • Do not allow grease or dust to contact the door lock wiring harness seal surface of the connector.

    • Reusing the door lock wiring harness seal or using a damaged door lock wiring harness seal may cause water intrusion. This may result in a malfunction of the front door lock assembly.


    1. B001LTT

      Install the front door inside locking cable assembly.

    2. B001LLN

      Engage the 3 claws.

    3. B001MLL

      Install the front door lock remote control cable assembly.

    4. Apply MP grease to the sliding parts of the front door lock assembly.

    5. B001LWO

      Install a new door lock wiring harness seal to the front door lock assembly.

    6. B001MP6E04
      Text in Illustration
      *1 Front Door Lock Open Rod

      Insert the front door lock open rod to the front door lock assembly.

    7. Make sure that the front door lock open rod is securely connected to the front door lock assembly.

    8. Using a T30 "TORX" socket wrench, install the front door lock assembly with the 3 screws.

      Torque:
      5.0 N*m  { 51 kgf*cm, 44 in.*lbf }

    9. Connect the connector.

  2. INSTALL FRONT DOOR OUTSIDE HANDLE COVER WITH LOCK CYLINDER ASSEMBLY (for Driver Side)

    Click here

  3. INSTALL FRONT DOOR REAR LOWER FRAME SUB-ASSEMBLY

    Click here

  4. INSTALL FRONT DOOR GLASS RUN

    Click here

  5. INSTALL FRONT DOOR GLASS SUB-ASSEMBLY

    Click here

  6. INSTALL FRONT DOOR SERVICE HOLE COVER

    Click here

  7. INSTALL FRONT DOOR TRIM BRACKET (for Driver Side)

    Click here

  8. INSTALL FRONT DOOR TRIM BRACKET (for Front Passenger Side)

    Click here

  9. INSTALL FRONT DOOR TRIM BOARD SUB-ASSEMBLY (for Driver Side)

    Click here

  10. INSTALL DOOR ARMREST COVER (for Driver Side)

    Click here

  11. INSTALL POWER WINDOW REGULATOR MASTER SWITCH ASSEMBLY WITH FRONT DOOR ARMREST BASE PANEL (for Driver Side)

    Click here

  12. INSTALL FRONT DOOR TRIM BOARD SUB-ASSEMBLY (for Front Passenger Side)

    Click here

  13. INSTALL DOOR ASSIST GRIP ASSEMBLY (for Front Passenger Side)

    Click here

  14. INSTALL DOOR ASSIST GRIP COVER (for Front Passenger Side)

    Click here

  15. INSTALL POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH FRONT DOOR ARMREST BASE PANEL (for Front Passenger Side)

    Click here

  16. INSTALL FRONT DOOR LOWER FRAME BRACKET GARNISH

    Click here

  17. INSTALL FRONT DOOR INSIDE HANDLE BEZEL PLUG

    Click here

  18. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  19. INSTALL REAR FLOOR BOARD UPPER NO. 3 PLATE

    Click here

  20. INSTALL DECK FLOOR BOX RH

    Click here

  21. INSTALL REAR NO. 3 FLOOR BOARD

    Click here

  22. INSTALL REAR DECK FLOOR BOX

    Click here

  23. INSTALL REAR NO. 2 FLOOR BOARD

    Click here

  24. INITIALIZE POWER WINDOW CONTROL SYSTEM

    Click here

  25. INSPECT SRS WARNING LIGHT

    Click here