CAN COMMUNICATION SYSTEM, Diagnostic DTC:U0265

DTC Code DTC Name
U0265 Lost Communication with Parking Assist Monitor Module

DESCRIPTION

DTC No. DTC Detection Condition Trouble Area
U0265 No communication from the rear television camera assembly continues.

  • Rear television camera assembly branch line or connector

  • Power source circuit of rear television camera assembly

  • Rear television camera assembly

Tech Tips

This diagnosis procedure is for when DTC U0265 is output by the power management control ECU (GTS display: PM1 Gateway).

WIRING DIAGRAM

A004YYTE07

CAUTION / NOTICE / HINT

Note


  • Turn the power switch off before measuring the resistances between CAN main bus lines and between CAN branch lines.

  • Turn the power switch off before inspecting CAN bus lines for a ground short.

  • After the power switch is turned off, check that the key reminder warning system and light reminder warning system are not operating.

  • Before measuring the resistance, leave the vehicle as is for at least 1 minute and do not operate the power switch, any other switches or the doors. If any doors need to be opened in order to check connectors, open the doors and leave them open.

Tech Tips


  • Operating the power switch, any other switches or a door triggers related ECU and sensor communication on the CAN. This communication will cause the resistance value to change.

  • Even after DTCs are cleared, if a DTC is stored again after driving the vehicle for a while, the malfunction may be occurring due to vibration of the vehicle. In such a case, wiggling the ECUs or wire harness while performing the inspection below may help determine the cause of the malfunction.

PROCEDURE


  1. RECONFIRM DTC OUTPUT


    1. Reconfirm DTCs.

      Tech Tips

      If DTC U1002 is output from PM1 Gateway of the power management control ECU, this indicates a V2 bus malfunction. Troubleshoot for DTC U1002 and check for malfunctions in the V2 bus.

      Result
      Result Proceed to
      U1002 is not output from power management control ECU (GTS display:PM1 Gateway) A
      U1002 is output from power management control ECU (GTS display:PM1 Gateway) B

    B

    GO TO DIAGNOSIS PROCEDURE INDICATED BY OUTPUT DTC Click here

    A

  2. RECONFIRM DTC OUTPUT (PARKING ASSIST SYSTEM)


    1. Reconfirm DTCs.

    2. Enter the following menus: Chassis / Advance Parking Guidance/Parking Assist Monitor / DTC.

      Result
      Result Proceed to
      C1621 is not output. A
      C1621 is output. B

    B

    GO TO DIAGNOSIS PROCEDURE INDICATED BY OUTPUT DTC Click here

    A

  3. CHECK FOR OPEN IN CAN BUS LINES (REAR TELEVISION CAMERA BRANCH LINE)


    1. Turn the power switch off.

    2. Disconnect the cable from the negative (-) auxiliary battery terminal.

    3. A004XV7E02
      Text in Illustration
      *a

      Front view of wire harness connector

      (to Rear Television Camera Assembly)

      Disconnect the TC5 rear television camera assembly connector.

    4. Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      V13-4 (CANH) - V13-1 (CANL) Cable disconnected from negative (-) auxiliary battery terminal 54 to 69 Ω

    OK

    REPLACE REAR TELEVISION CAMERA ASSEMBLY Click here

    NG

    REPAIR OR REPLACE CAN BRANCH LINE OR CONNECTOR (REAR TELEVISION CAMERA ASSEMBLY)