ULTRASONIC SENSOR(for Rear Side) INSTALLATION

PROCEDURE


  1. INSTALL NO. 1 ULTRASONIC SENSOR

  2. INSTALL ULTRASONIC SENSOR CLIP (for Corner Sensor)

    Tech Tips

    Use the same procedure for all ultrasonic sensor clips.


    1. A00506Q

      Engage the claw to install the ultrasonic sensor clip to the No. 1 ultrasonic sensor.

      Tech Tips

      This illustration is for the LH side. The orientation for the RH side is the opposite of the LH side.

  3. INSTALL ULTRASONIC SENSOR CLIP (for Back Sensor)

    Tech Tips

    Use the same procedure for all ultrasonic sensor clips.


    1. A004ZT4

      Engage the claw to install the ultrasonic sensor clip to the No. 1 ultrasonic sensor.

      Tech Tips

      This illustration is for the LH side. The orientation for the RH side is the opposite of the LH side.

  4. INSTALL NO. 1 ULTRASONIC SENSOR RETAINER

    Tech Tips


    • Use the same procedure for all No. 1 ultrasonic sensor retainers.

    • Perform this step only when necessary.

    • If a No. 1 ultrasonic sensor retainer has been removed, replace it with a new one. Install the ultrasonic sensor with clip with a new No. 1 ultrasonic sensor retainer as a set to the rear bumper assembly.


    1. A004WV9

      Engage the 2 claws and install a new No. 1 ultrasonic sensor retainer to the ultrasonic sensor with clip.

    2. Clean the rear bumper cover surface.


      1. Remove the double-sided tape from the rear bumper cover.

      2. Wipe off any tape adhesive residue with cleaner.

    3. A004YSZ

      Using a brush or felt, apply primer or equivalent to the No. 1 ultrasonic sensor retainer installation area.

      Text in Illustration
      B001LAT Primer

      Note


      • Use a clean brush or felt.

      • Do not touch the rear bumper assembly until the primer has dried.

    4. Peel off the release paper from the new No. 1 ultrasonic sensor retainer.

    5. A004ZC3E02
      Text in Illustration
      *a Protrusion of the mark

      Align the No. 1 ultrasonic sensor retainer with ultrasonic sensor with the mark on the rear bumper cover and install it as shown in the illustration.

      Note


      • Align the connector with the protrusion of the mark and connect it.

      • Press on the areas indicated by the arrows in the illustration with a force of 30 N (3.0 kgf) for 3 seconds and install the No. 1 ultrasonic sensor retainer firmly so that there is no clearance between the No. 1 ultrasonic sensor retainer and rear bumper cover.

  5. INSTALL ULTRASONIC SENSOR WITH CLIP

    Tech Tips

    Use the same procedure for all ultrasonic sensor with clips.


    1. Engage the 2 claws to install the ultrasonic sensor with clip.

    2. Engage the clamp and connect the connector.

  6. INSTALL REAR BUMPER ASSEMBLY

    Click here