REAR VIEW MONITOR SYSTEM(for Inner Rear View Mirror Type) Inner Rear View Mirror Power Source Circuit

DESCRIPTION

This circuit detects the state of the power switch, and sends it to the inner rear view mirror assembly.

WIRING DIAGRAM

A004VVPE02

CAUTION / NOTICE / HINT

Note

Inspect the fuses for circuits related to this system before performing the following inspection procedure.

PROCEDURE


  1. CHECK HARNESS AND CONNECTOR (BATTERY - INNER REAR VIEW MIRROR ASSEMBLY)


    1. Disconnect the T9 inner rear view mirror assembly connector.

    2. Measure the voltage according to the value(s) in the table below.

      Standard Voltage
      Tester Connection Switch Condition Specified Condition
      T9-1 (IG) - T9-2 (E) Power switch on (IG) 11 to 14 V
      Power switch off Below 1 V

    OK

    PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE Click here

    NG

    REPAIR OR REPLACE HARNESS OR CONNECTOR