PARKING ASSIST MONITOR SYSTEM(w/ Parallel Parking Assist Function) Guide Lines are Displayed with Vehicle Center Line

DESCRIPTION

The rear television camera assembly can create parking guide lines. Because this function is not necessary on vehicles with the parking assist monitor system, the guide line creation function of the rear television camera assembly is disabled.

WIRING DIAGRAM

B001LKYE36
*a Rear Television Camera Assembly

CAUTION / NOTICE / HINT

Note


  • When "System initializing" is displayed on the multi-display after disconnecting the cable from the negative (-) auxiliary battery terminal, correct the steering angle neutral point Click here.

  • Depending on the parts that are replaced or operations that are performed during vehicle inspection or maintenance, calibration of other systems as well as the parking assist monitor system may be needed Click here.

PROCEDURE


  1. CHECK SCREEN MODE


    1. B001LCHE01
      Text in Illustration
      *a Vehicle Center Line

      Check the parking assist monitor screen.

      Result
      Result Proceed to
      Guide lines are displayed with vehicle center lines A
      Guide lines are displayed without vehicle center lines B

    B

    USE SIMULATION METHOD TO CHECK Click here

    A

  2. CHECK HARNESS AND CONNECTOR (REAR TELEVISION CAMERA ASSEMBLY - BODY GROUND)


    1. Disconnect the V14 rear television camera assembly connector.

    2. Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      V14-1 (CURT) - Body ground Always Below 1 Ω

    OK

    REPLACE REAR TELEVISION CAMERA ASSEMBLY Click here

    NG

    REPAIR OR REPLACE HARNESS OR CONNECTOR