LEXUS PARKING ASSIST-SENSOR SYSTEM, Diagnostic DTC:C1AE8

DTC Code DTC Name
C1AE8 Rear Right Center Sensor Malfunction

DESCRIPTION

The No. 1 ultrasonic sensor (rear right center sensor) is installed on the rear bumper. The ECU detects obstacles based on signals received from the No. 1 ultrasonic sensor (rear right center sensor). If the No. 1 ultrasonic sensor (rear right center sensor) has an open circuit or other malfunction, it will not function normally.

DTC No. DTC Detection Condition Trouble Area
C1AE8 A malfunction of the No. 1 ultrasonic sensor (rear right center sensor).

  • No. 1 ultrasonic sensor (rear right center sensor)

  • Harness or connector

  • Clearance warning ECU assembly

WIRING DIAGRAM

B001LIFE01

CAUTION / NOTICE / HINT

Note

If DTCs are output after repairs, turn the power switch on (IG) and turn the clearance sonar main switch on. Then clear the DTCs Click here.

PROCEDURE


  1. INSPECT NO. 1 ULTRASONIC SENSOR (REAR RIGHT CENTER SENSOR)


    1. Remove the No. 1 ultrasonic sensor (rear right center sensor) Click here.

    2. B001MIGE01
      Text in Illustration
      *a

      Component without harness connected

      (No. 1 Ultrasonic Sensor (Rear Right Center Sensor))

      Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      2 (S) - 1 (E) Always 20 to 40 kΩ

    NG

    REPLACE NO. 1 ULTRASONIC SENSOR (REAR RIGHT CENTER SENSOR) Click here

    OK

  2. CHECK HARNESS AND CONNECTOR (NO. 1 ULTRASONIC SENSOR (REAR RIGHT CENTER SENSOR) - CLEARANCE WARNING ECU ASSEMBLY)


    1. Disconnect the U7 No. 1 ultrasonic sensor (rear right center sensor) connector.

    2. Disconnect the A78 clearance warning ECU assembly connector.

    3. Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      U7-2 (S) - A78-6 (S3) Always Below 1 Ω
      U7-1 (E) - A78-7 (E3) Always Below 1 Ω
      U7-2 (S) - Body ground Always 10 kΩ or higher
      U7-1 (E) - Body ground Always 10 kΩ or higher

    OK

    REPLACE CLEARANCE WARNING ECU ASSEMBLY Click here

    NG

    REPAIR OR REPLACE HARNESS OR CONNECTOR