REAR AXLE HUB INSTALLATION

CAUTION / NOTICE / HINT

PROCEDURE

1. INSTALL REAR AXLE HUB AND BEARING ASSEMBLY

   
   

   1. Install the rear axle hub and bearing assembly and rear disc brake dust cover sub-assembly to the rear axle carrier sub-assembly with the 4 bolts.

      Torque:

      90 N*m  { 918 kgf*cm, 66 ft.*lbf }

2. CONNECT REAR SPEED SENSOR WIRE

   Click here

3. INSPECT REAR AXLE HUB BEARING LOOSENESS

   Click here

4. INSPECT REAR AXLE HUB RUNOUT

   Click here

5. INSTALL REAR DISC

   Click here

6. INSTALL REAR DISC BRAKE CALIPER ASSEMBLY

   Click here

7. CONNECT NO. 3 PARKING BRAKE CABLE ASSEMBLY

   Click here

8. INSTALL PARKING BRAKE LEVER PROTECTOR

   Click here

9. INSTALL REAR SUSPENSION ARM COVER

   Click here

10. ADJUST PARKING BRAKE

    Click here

11. INSTALL LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY (for LHD)

    Click here

12. INSTALL INSTRUMENT SIDE PANEL LH (for LHD)

    Click here

13. INSTALL FRONT DOOR OPENING TRIM WEATHERSTRIP LH (for LHD)

    Click here

14. INSTALL NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY (for LHD)

    Click here

15. INSTALL NO. 2 AIR DUCT SUB-ASSEMBLY (for RHD)

    Click here

16. INSTALL NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY (for RHD)

    Click here

17. INSTALL REAR WHEEL

    Torque:

    103 N*m  { 1050 kgf*cm, 76 ft.*lbf }

18. CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL

    
    

    1. Connect the cable to the negative (-) auxiliary battery terminal.

       
       

       • for 2ZR-FXE: Click here

       • for 5ZR-FXE: Click here

    2. Connect the reservoir level switch connector.

    3. Clear the DTCs Click here.

19. CHECK FOR SPEED SENSOR SIGNAL

    Click here