REAR AXLE HUB REMOVAL

CAUTION / NOTICE / HINT

Note

When the brake pedal is first depressed after replacing the brake pads or pushing back the disc brake piston, DTC C1214 may be output. As there is no malfunction, clear the DTC.

Tech Tips


  • Use the same procedure for the RH side and LH side.

  • The procedure listed below is for the LH side.

PROCEDURE


  1. PRECAUTION

    Note

    After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work Click here.

  2. DISABLE BRAKE CONTROL

    Click here

  3. REMOVE REAR WHEEL

  4. REMOVE NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY (for LHD)

    Click here

  5. DISCONNECT FRONT DOOR OPENING TRIM WEATHERSTRIP LH (for LHD)

    Click here

  6. REMOVE INSTRUMENT SIDE PANEL LH (for LHD)

    Click here

  7. REMOVE LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY (for LHD)

    Click here

  8. LOOSEN PARKING BRAKE CABLE (for LHD)

    Click here

  9. REMOVE NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY (for RHD)

    Click here

  10. REMOVE NO. 2 AIR DUCT SUB-ASSEMBLY (for RHD)

    Click here

  11. LOOSEN PARKING BRAKE CABLE (for RHD)

    Click here

  12. REMOVE REAR SUSPENSION ARM COVER

    Click here

  13. REMOVE PARKING BRAKE LEVER PROTECTOR

    Click here

  14. DISCONNECT NO. 3 PARKING BRAKE CABLE ASSEMBLY

    Click here

  15. SEPARATE REAR DISC BRAKE CALIPER ASSEMBLY

    Click here

  16. REMOVE REAR DISC

    Click here

  17. DISCONNECT REAR SPEED SENSOR WIRE

    Click here

  18. REMOVE REAR AXLE HUB AND BEARING ASSEMBLY


    1. B001M90

      Remove the 4 bolts, rear disc brake dust cover sub-assembly and the rear axle hub and bearing assembly from the rear axle carrier sub-assembly.