SHIFT LEVER REMOVAL

PROCEDURE

1. PRECAUTION

   Note

   
   

   • If the transmission instrument panel shift assembly is to be replaced with a new one, it is necessary to clear the learned shift sensor voltage values by disconnecting and reconnecting the cable of the negative (-) auxiliary battery terminal.

   • After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work Click here.

2. REMOVE REAR NO. 2 FLOOR BOARD

   Click here

3. REMOVE REAR DECK FLOOR BOX

   Click here

4. REMOVE REAR NO. 3 FLOOR BOARD

   Click here

5. REMOVE DECK FLOOR BOX RH

   Click here

6. REMOVE REAR FLOOR BOARD UPPER NO. 3 PLATE

   Click here

7. DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL

   Note

   When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

8. REMOVE SHIFT LEVER KNOB SUB-ASSEMBLY

   Click here

9. REMOVE LOWER CENTER INSTRUMENT PANEL FINISH PANEL

   Click here

10. REMOVE UPPER NO. 2 CONSOLE PANEL GARNISH

    Click here

11. REMOVE UPPER NO. 1 CONSOLE PANEL GARNISH

    Click here

12. REMOVE UPPER CONSOLE PANEL SUB-ASSEMBLY

    Click here

13. REMOVE INTEGRATION CONTROL AND PANEL ASSEMBLY

    Click here

14. REMOVE REAR CONSOLE BOX POCKET

    Click here

15. REMOVE CONSOLE BOX CARPET

    Click here

16. REMOVE REAR CONSOLE BOX ASSEMBLY

    Click here

17. REMOVE CONSOLE BOX INSERT

    Click here

18. REMOVE CONSOLE BOX LH (for LHD)

    Click here

19. REMOVE CONSOLE BOX RH (for RHD)

    Click here

20. REMOVE TRANSMISSION INSTRUMENT PANEL SHIFT ASSEMBLY

    
    

    1. 

       Remove the 3 nuts and separate the transmission instrument panel shift assembly.

    2. 

       Disconnect the 2 connectors and remove the transmission instrument panel shift assembly.