DRIVING SUPPORT ECU INSTALLATION

CAUTION / NOTICE / HINT

PROCEDURE

1. INSTALL DRIVING SUPPORT ECU ASSEMBLY

   
   

   1. Connect the connector.

      Note

      If the driving support ECU assembly has been struck or dropped, replace the driving support ECU assembly with a new one.

   2. Install the driving support ECU assembly with the nut.

      Torque:

      7.5 N*m  { 76 kgf*cm, 66 in.*lbf }

2. INSTALL RADIO RECEIVER ASSEMBLY WITH BRACKET

   Click here

3. INSTALL AIR CONDITIONING CONTROL ASSEMBLY

   Click here

4. INSTALL INTEGRATION CONTROL AND PANEL ASSEMBLY

   Click here

5. INSTALL UPPER CONSOLE PANEL SUB-ASSEMBLY

   Click here

6. INSTALL UPPER NO. 1 CONSOLE PANEL GARNISH

   Click here

7. INSTALL UPPER NO. 2 CONSOLE PANEL GARNISH

   Click here

8. INSTALL LOWER CENTER INSTRUMENT PANEL FINISH PANEL

   Click here

9. INSTALL SHIFT LEVER KNOB SUB-ASSEMBLY

   Click here

10. INSTALL NO. 3 INSTRUMENT CLUSTER FINISH PANEL GARNISH (for Metal Finish Panel and Urethane Panel)

    Click here

11. INSTALL NO. 3 INSTRUMENT CLUSTER FINISH PANEL GARNISH (for Wood Panel and Bamboo Panel)

    Click here

12. INSTALL INSTRUMENT SIDE PANEL RH

    Click here

13. INSTALL FRONT DOOR OPENING TRIM WEATHERSTRIP RH

    Click here

14. CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Click here

15. INSTALL REAR FLOOR BOARD UPPER NO. 3 PLATE

    Click here

16. INSTALL DECK FLOOR BOX RH

    Click here

17. INSTALL REAR NO. 3 FLOOR BOARD

    Click here

18. INSTALL REAR DECK FLOOR BOX

    Click here

19. INSTALL REAR NO. 2 FLOOR BOARD

    Click here

20. INSPECT SRS WARNING LIGHT

    Click here