CRUISE CONTROL SYSTEM Cruise Control Switch Circuit

DESCRIPTION


WIRING DIAGRAM

B001MUYE82

CAUTION / NOTICE / HINT

Note

The vehicle is equipped with a Supplemental Restraint System (SRS) which includes components such as airbags. Before servicing (including removal or installation of parts), be sure to read the precaution for Supplemental Restraint System.

Click here

PROCEDURE


  1. READ VALUE USING GTS


    1. B001ML4E21
      Text in Illustration
      *a ON/OFF
      *b -/SET
      *c +/RES
      *d CANCEL

      Connect the GTS to the DLC3.

    2. Turn the power switch on (IG).

    3. Turn the GTS on.

    4. Enter the following menus: Powertrain / Cruise Control / Data List.

    5. Check the Data List to confirm proper function of the Cruise control main switch.

      Cruise Control
      Tester Display Measurement Item Range Normal Condition Diagnostic Note
      Cancel Switch CANCEL switch status ON or OFF

      ON: CANCEL switch on

      OFF: CANCEL switch off

      		 -
      -SET Switch -SET switch status ON or OFF

      ON: -SET switch on

      OFF: -SET switch off

      		 -
      +RES Switch +RES switch status ON or OFF

      ON: +RES switch on

      OFF: +RES switch off

      		 -
      Cruise Main Switch Operation Condition Cruise control main switch (ON/OFF button) status ON or OFF

      ON: Cruise control main switch pushed

      OFF: Cruise control main switch not pushed

      		 -
      OK
      When the Cruise control main switch is operated, the display changes as shown above.

    OK

    PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE Click here

    NG

  2. INSPECT CRUISE CONTROL MAIN SWITCH


    1. Remove the cruise control main switch.

      Click here

    2. Inspect the cruise control main switch.

      Click here


    NG

    REPLACE CRUISE CONTROL MAIN SWITCH Click here

    OK

  3. INSPECT STEERING PAD SWITCH ASSEMBLY


    1. Remove the steering pad switch assembly.

      Click here

    2. Inspect the steering pad switch assembly.

      Click here


    NG

    REPLACE STEERING PAD SWITCH ASSEMBLY Click here

    OK

  4. CHECK SPIRAL CABLE WITH SENSOR SUB-ASSEMBLY


    1. Remove the spiral cable with sensor sub-assembly.

      Click here

    2. Inspect the spiral cable with sensor sub-assembly.

      Click here


    NG

    REPLACE SPIRAL CABLE WITH SENSOR SUB-ASSEMBLY Click here

    OK

  5. CHECK HARNESS AND CONNECTOR (SPIRAL CABLE WITH SENSOR SUB-ASSEMBLY - POWER MANAGEMENT CONTROL ECU AND BODY GROUND)


    1. Disconnect the H30 spiral cable with sensor sub-assembly connector.

    2. Disconnect the H4 power management control ECU connector.

    3. Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      H30-7 (CCS) - H4-22 (CCS) Always Below 1 Ω
      H30-2 (ECC) - Body ground Always Below 1 Ω
      H30-7 (CCS) or H4-22 (CCS) - Body ground Always 10 kΩ or higher

    OK

    REPLACE POWER MANAGEMENT CONTROL ECU Click here

    NG

    REPAIR OR REPLACE HARNESS OR CONNECTOR