CYLINDER HEAD GASKET REMOVAL

PROCEDURE


  1. REMOVE CAMSHAFT HOUSING SUB-ASSEMBLY

    Click here

  2. REMOVE NO. 1 EXHAUST MANIFOLD HEAT INSULATOR

    Click here

  3. REMOVE MANIFOLD STAY

    Click here

  4. REMOVE EXHAUST MANIFOLD

    Click here

  5. REMOVE NO. 1 VALVE ROCKER ARM SUB-ASSEMBLY

    Click here

  6. REMOVE VALVE LASH ADJUSTER ASSEMBLY

    Click here

  7. REMOVE VALVE STEM CAP

    Click here

  8. REMOVE CYLINDER HEAD SUB-ASSEMBLY


    1. B001KF4E01

      Using a 10 mm bi-hexagon wrench, uniformly loosen and remove the 10 cylinder head bolts and 10 plate washers in several steps in the sequence shown in the illustration.

      Note


      • Be careful not to drop washers into the cylinder head.

      • Head warpage or cracking could result from removing the bolts in the wrong order.

    2. Using a screwdriver with its tip wrapped with tape, pry between the cylinder head and cylinder block, and remove the cylinder head.

      Note

      Be careful not to damage the contact surfaces of the cylinder head and cylinder block.

  9. REMOVE CYLINDER HEAD GASKET


    1. B001KY6

      Remove the cylinder head gasket.