COMBINATION SWITCH REMOVAL

PROCEDURE


  1. PRECAUTION

    Note

    After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notice before proceeding with work Click here.

  2. REMOVE REAR NO. 2 FLOOR BOARD

    Click here

  3. REMOVE REAR DECK FLOOR BOX

    Click here

  4. REMOVE REAR NO. 3 FLOOR BOARD

    Click here

  5. REMOVE DECK FLOOR BOX RH

    Click here

  6. REMOVE REAR FLOOR BOARD UPPER NO. 3 PLATE

    Click here

  7. DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  8. REMOVE LOWER CENTER INSTRUMENT PANEL FINISH PANEL

    Click here

  9. REMOVE UPPER NO. 1 CONSOLE PANEL GARNISH

    Click here

  10. REMOVE UPPER NO. 2 CONSOLE PANEL GARNISH

    Click here

  11. REMOVE UPPER CONSOLE PANEL SUB-ASSEMBLY

    Click here

  12. REMOVE SHIFT LEVER KNOB SUB-ASSEMBLY

    Click here

  13. REMOVE COMBINATION SWITCH ASSEMBLY


    1. B001N9C

      Disengage the 6 claws and 2 guides.

    2. Disengage the clamp.

    3. Disconnect each connector and remove the combination switch assembly.

    4. B001LBW

      Remove the 2 screws and position indicator housing assembly from the combination switch assembly.

    5. B001MKP

      Disengage the 2 claws and remove the transmission shift main switch.