AIR FUEL RATIO SENSOR INSTALLATION

PROCEDURE


  1. INSTALL AIR FUEL RATIO SENSOR


    1. B001M29E09
      Text in Illustration
      *a

      Fulcrum Length

      30 mm
      *b

      Fulcrum Length

      300 mm

      Using SST, install the air fuel ratio sensor.

      SST
      09224-00010
      Torque:
      without SST
      44 N*m  { 449 kgf*cm, 32 ft.*lbf }
      with SST
      40 N*m  { 408 kgf*cm, 30 ft.*lbf }

      Note


      • The "with SST" torque value is effective when using SST with a fulcrum length of 30 mm (1.18 in.) and a torque wrench with a fulcrum length of 300 mm (11.8 in.) Click here.

      • The "with SST" torque value is effective when SST is parallel to the torque wrench.

    2. Connect the air fuel ratio sensor connector and clamp.

  2. INSTALL NO. 2 CYLINDER HEAD COVER

    Click here

  3. INSPECT FOR EXHAUST GAS LEAK

  4. INSTALL OUTER COWL TOP PANEL SUB-ASSEMBLY

    Click here

  5. INSTALL COWL BODY MOUNTING REINFORCEMENT LH

    Click here

  6. INSTALL NO. 2 HEATER AIR DUCT SPLASH SHIELD SEAL

    Click here

  7. INSTALL NO. 1 HEATER AIR DUCT SPLASH SHIELD SEAL

    Click here

  8. INSTALL WINDSHIELD WIPER MOTOR AND LINK ASSEMBLY

    Click here