HEATED OXYGEN SENSOR INSTALLATION

PROCEDURE


  1. INSTALL HEATED OXYGEN SENSOR


    1. B001LQ4E08
      Text in Illustration
      *a

      Fulcrum Length

      30 mm
      *b

      Fulcrum Length

      300 mm

      Using SST, install the heated oxygen sensor onto the front exhaust pipe.

      SST
      09224-00010
      Torque:
      without SST
      44 N*m  { 449 kgf*cm, 32 ft.*lbf }
      with SST
      40 N*m  { 408 kgf*cm, 30 ft.*lbf }

      Note


      • The "with SST" torque value is effective when using SST with a fulcrum length of 30 mm (1.18 in.) and a torque wrench with a fulcrum length of 300 mm (11.8 in.) Click here.

      • The "with SST" torque value is effective when SST is parallel to the torque wrench.

    2. Connect the wire harness to install the wire harness clamp bracket.

    3. Install the wire harness clamp bracket with the bolt.

      Torque:
      13 N*m  { 127 kgf*cm, 9 ft.*lbf }

    4. Install the wire harness bracket.

    5. Connect the heated oxygen sensor connector.

  2. INSPECT FOR EXHAUST GAS LEAK

  3. INSTALL FRONT NO. 3 ENGINE UNDER COVER


    1. Install the front No. 3 engine under cover with the 4 clips.