ECM REMOVAL

PROCEDURE


  1. PRECAUTION

    Note


    • Perform the Vehicle Identification Number (VIN) registration when replacing the ECM Click here.

    • After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notice before proceeding with work Click here.

  2. REMOVE REAR NO. 2 FLOOR BOARD

    Click here

  3. REMOVE REAR DECK FLOOR BOX

    Click here

  4. REMOVE REAR NO. 3 FLOOR BOARD

    Click here

  5. REMOVE DECK FLOOR BOX RH

    Click here

  6. REMOVE REAR FLOOR BOARD UPPER NO. 3 PLATE

    Click here

  7. DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  8. REMOVE INVERTER WITH CONVERTER ASSEMBLY

    Click here

  9. SEPARATE INVERTER RESERVE TANK ASSEMBLY


    1. B001LX0

      Remove the 2 bolts and separate the inverter reserve tank assembly.

  10. REMOVE ECM


    1. B001MN7

      Separate the wire harness clamp.

    2. Disconnect the 2 ECM connectors.


      1. B001M5B

        Disconnect the wire harness clamp.

      2. Push the locks on the 2 levers, then raise the levers, and disconnect the 2 ECM connectors.

        Note

        After disconnecting the connectors, make sure that dirt, water or other foreign matter does not contact the connecting parts of the connectors.

    3. B001L6W

      Remove the 2 bolts and ECM.

    4. Remove the 4 screws and 2 ECM brackets.