TELEMATICS SYSTEM(w/ Telematics Transceiver for G-BOOK) Emergency Call Switch Indicator Circuit

WIRING DIAGRAM

*a	Telematics Transceiver
*b	Map Light Assembly

CAUTION / NOTICE / HINT

PROCEDURE

1. CHECK HARNESS AND CONNECTOR (TELEMATICS TRANSCEIVER - MAP LIGHT ASSEMBLY)

   
   

   1. Disconnect the H145 telematics transceiver connector.

   2. Disconnect the T6 map light assembly connector.

   3. Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition H145-11 (IND1) - T6-19 (IND1) Always Below 1 Ω H145-12 (IND2) - T6-18 (IND2) Always Below 1 Ω T6-3 (GND3) - Body ground Always Below 1 Ω H145-11 (IND1) - Body ground Always 10 kΩ or higher H145-12 (IND2) - Body ground Always 10 kΩ or higher

   
   

   NG

   REPAIR OR REPLACE HARNESS OR CONNECTOR

   OK

2. INSPECT MAP LIGHT ASSEMBLY

   
   

   1. Remove the map light assembly Click here.

   2. Connect 2 dry-cell batteries in series.

   3. 

      Text in Illustration

      *a	Component without harness connected (Map Light Assembly)

      Connect a positive (+) lead from the batteries to terminal 19 (IND1) or 18 (IND2), and a negative (-) lead to terminal 3 (GND3) of the map light assembly connector.

   4. Check if an emergency call switch indicator comes on.

      OK
      The indicator (red) comes on when the positive (+) lead from the batteries is connected to terminal 19 (IND1) and the negative (-) lead is connected to terminal 3 (GND3).
      The indicator (green) comes on when the positive (+) lead from the batteries is connected to terminal 18 (IND2) and the negative (-) lead is connected to terminal 3 (GND3).

   
   

   OK

   REPLACE TELEMATICS TRANSCEIVER Click here

   NG

   REPLACE MAP LIGHT ASSEMBLY Click here