HARD DISK DRIVE REMOVAL

PROCEDURE


  1. PRECAUTION

    Note


    • After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work Click here.

    • A Hard Disk Drive (HDD) is built into the radio receiver assembly to store map and other data, and is used for the navigation system. Therefore, care must be taken for the following points when handling the radio receiver assembly.

    • When removing the hard disk drive, eliminate static electricity by touching the vehicle body to prevent components from being damaged.

  2. REMOVE REAR NO. 2 FLOOR BOARD

    Click here

  3. REMOVE REAR DECK FLOOR BOX

    Click here

  4. REMOVE REAR NO. 3 FLOOR BOARD

    Click here

  5. REMOVE DECK FLOOR BOX RH

    Click here

  6. REMOVE REAR FLOOR BOARD UPPER NO. 3 PLATE

    Click here

  7. DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  8. DISCONNECT FRONT DOOR OPENING TRIM WEATHERSTRIP

    Tech Tips

    Use the same procedure for the RH and LH side Click here.

  9. REMOVE INSTRUMENT SIDE PANEL

    Click here

  10. REMOVE NO. 3 INSTRUMENT CLUSTER FINISH PANEL GARNISH (for Metal Finish Panel and Urethane Panel)

    Click here

  11. REMOVE NO. 3 INSTRUMENT CLUSTER FINISH PANEL GARNISH (for Wood Panel and Bamboo Panel)

    Click here

  12. REMOVE LOWER CENTER INSTRUMENT PANEL FINISH PANEL

    Click here

  13. REMOVE UPPER NO. 2 CONSOLE PANEL GARNISH

    Click here

  14. REMOVE UPPER NO. 1 CONSOLE PANEL GARNISH

    Click here

  15. REMOVE UPPER CONSOLE PANEL SUB-ASSEMBLY

    Click here

  16. REMOVE SHIFT LEVER KNOB SUB-ASSEMBLY

    Click here

  17. REMOVE INTEGRATION CONTROL AND PANEL ASSEMBLY

    Click here

  18. REMOVE AIR CONDITIONING CONTROL ASSEMBLY

    Click here

  19. REMOVE RADIO RECEIVER ASSEMBLY WITH BRACKET

    Click here

  20. REMOVE TELEMATICS TRANSCEIVER WITH BRACKET

    Click here

  21. REMOVE NO. 2 RADIO BRACKET

    Click here

  22. REMOVE HARD DISK DRIVE


    1. B001LFX

      Remove the 3 screws and cover.

    2. B001LE3E02
      Text in Illustration
      *a Protective Tape

      Using a screwdriver with its tip wrapped with protective tape, slide the hard disk drive in the direction shown by the arrow to remove it.