NAVIGATION SYSTEM Display Signal Circuit between Navigation Receiver Assembly and Stereo Jack Adapter

DESCRIPTION

The No. 1 stereo jack adapter assembly sends the display signal from an external device to the radio receiver assembly via this circuit.

WIRING DIAGRAM

B001L3TE02
*1 (Shielded)
*2 No. 1 Stereo Jack Adapter Assembly
*3 Radio Receiver Assembly

PROCEDURE


  1. CHECK HARNESS AND CONNECTOR (RADIO RECEIVER ASSEMBLY - NO. 1 STEREO JACK ADAPTER ASSEMBLY)


    1. Disconnect the H159 radio receiver assembly connector.

    2. Disconnect the H167 No. 1 stereo jack adapter assembly connector.

    3. Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      H159-6 (VV+) - H167-8 (VV+) Always Below 1 Ω
      H159-14 (VV-) - H167-9 (VV-) Always Below 1 Ω
      H159-13 (SG) - H167-10 (SG) Always Below 1 Ω
      H159-6 (VV+) - Body ground Always 10 kΩ or higher
      H159-14 (VV-) - Body ground Always 10 kΩ or higher
      H159-13 (SG) - Body ground Always 10 kΩ or higher

    OK

    PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE Click here

    NG

    REPAIR OR REPLACE HARNESS OR CONNECTOR