HEATED STEERING WHEEL CONTROLLER INSTALLATION

CAUTION / NOTICE / HINT

Note


  • Do not replace the spiral cable with the auxiliary battery connected and the power switch on (IG).

  • Do not rotate the spiral cable without the steering wheel with the auxiliary battery connected and the power switch on (IG).

  • Ensure that the steering wheel is installed and aligned straight when inspecting the steering sensor.

  • Do not remove the steering sensor from the spiral cable.

PROCEDURE


  1. INSTALL STEERING WHEEL HEATER CONTROL ASSEMBLY


    1. Install the steering wheel heater control assembly to the lower steering wheel boss cover with the 2 screws.

      Torque:
      0.8 N*m  { 8 kgf*cm, 7 in.*lbf }

    2. Engage the clamp.

  2. INSTALL LOWER STEERING WHEEL BOSS COVER

    Click here

  3. INSTALL STEERING SHAKE DAMPER

    Click here

  4. INSTALL STEERING PAD SWITCH ASSEMBLY

    Click here

  5. INSTALL CRUISE CONTROL SWITCH (w/ Cruise Control System)

    Click here

  6. ALIGN FRONT WHEELS FACING STRAIGHT AHEAD

  7. ADJUST SPIRAL CABLE WITH SENSOR SUB-ASSEMBLY

    Click here

  8. INSTALL STEERING WHEEL ASSEMBLY

    Click here

  9. CHECK STEERING WHEEL CENTER POINT

  10. INSTALL HORN BUTTON ASSEMBLY

    Click here