PARKING BRAKE PEDAL(for LHD) INSTALLATION

PROCEDURE


  1. INSTALL PARKING BRAKE CONTROL PEDAL ASSEMBLY


    1. B001L0I

      Install the parking brake control pedal assembly with the bolt and 2 nuts.

      Torque:
      15 N*m  { 148 kgf*cm, 11 ft.*lbf }
    2. B001M37

      Connect the parking brake switch connector.

    3. Engage the wire harness clamp.

    4. B001MYE

      Install the No. 1 parking brake cable assembly with the 5 bolts and nut.

      Torque:
      15 N*m  { 148 kgf*cm, 11 ft.*lbf }

    5. Engage the cable with the clamp.

    6. B001L7VE01
      Text in Illustration
      *1 Lock Nut
      *2 Adjusting Nut

      Temporarily install the lock nut.

      Tech Tips

      After adjusting parking brake pedal travel, tighten the lock nut.

  2. CONNECT NO. 1 PARKING BRAKE PULL ROD SUB-ASSEMBLY


    1. B001KTUE01
      Text in Illustration
      *a Turn
      *b Hold

      Connect the No. 1 parking brake pull rod sub-assembly to the parking brake control pedal assembly as shown in the illustration.

      Torque:
      5.4 N*m  { 55 kgf*cm, 48 in.*lbf }

  3. INSTALL FRONT FLOOR CENTER REINFORCEMENT


    1. B001KGB

      Install the front floor center reinforcement with the 4 bolts.

      Torque:
      27 N*m  { 275 kgf*cm, 20 ft.*lbf }

  4. INSTALL YAW RATE AND ACCELERATION SENSOR

    Click here

  5. INSTALL NO. 2 CONSOLE BOX MOUNTING BRACKET


    1. Install the No. 2 console box mounting bracket with the 2 bolts.

    2. Engage the clamp.

  6. INSTALL NO. 1 ELECTRICAL KEY OSCILLATOR

    Click here

  7. INSTALL AIR CONDITIONING UNIT ASSEMBLY

    Click here

  8. ADJUST PARKING BRAKE PEDAL TRAVEL

    Click here

  9. INSPECT BRAKE WARNING LIGHT

    Click here