REAR BRAKE FLEXIBLE HOSE REMOVAL

CAUTION / NOTICE / HINT

Note

If the left and right hoses are disconnected at the same time, be sure to place a mark on each hose to indicate its installation position.

Tech Tips


  • Use the same procedure for the LH side and RH side.

  • The following procedure is for the LH side.

PROCEDURE


  1. PRECAUTION

    Note

    After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work Click here.

  2. DISABLE BRAKE CONTROL

    Click here

  3. REMOVE REAR WHEEL

  4. DRAIN BRAKE FLUID

    Note

    If brake fluid leaks onto any painted surface, immediately wash it off.

  5. REMOVE REAR FLEXIBLE HOSE


    1. B001N42

      Using a union nut wrench, disconnect the brake line while holding the rear flexible hose with a wrench.

      Note


      • Do not bend or damage the brake line.

      • Do not allow any foreign matter such as dirt or dust to enter the brake line from the connecting points.

    2. Remove the clip from the rear flexible hose.

    3. B001M36

      Remove the union bolt, gasket, bolt and rear flexible hose.