BRAKE PEDAL(for LHD) INSTALLATION

PROCEDURE

1. INSTALL BRAKE PEDAL PAD

2. INSTALL BRAKE PEDAL SUPPORT ASSEMBLY

   
   

   1. Install the nut to the brake pedal support assembly.

   2. Install the brake pedal support assembly with the 4 nuts.

      Torque:

      13 N*m  { 130 kgf*cm, 9 ft.*lbf }

   3. Engage the clamp.

   4. Install the brake pedal support assembly to the instrument panel reinforcement with the bolt.

      Torque:

      24 N*m  { 241 kgf*cm, 17 ft.*lbf }

3. INSTALL PUSH ROD PIN

   
   

   1. Apply lithium soap base glycol grease to the push rod pin and installation hole of the brake pedal sub-assembly.

   2. Install the push rod pin and a new clip to connect the push rod clevis to the brake pedal sub-assembly.

4. INSTALL BRAKE PEDAL RETURN SPRING

   
   

   1. Install the brake pedal return spring to the brake pedal support assembly and push rod pin.

5. INSTALL STOP LIGHT SWITCH MOUNTING ADJUSTER

6. INSTALL STOP LIGHT SWITCH ASSEMBLY

   Click here

7. INSTALL BRAKE PEDAL STROKE SENSOR ASSEMBLY

   Click here

8. INSTALL POWER STEERING ECU ASSEMBLY

   Click here

9. INSTALL LOWER NO. 1 INSTRUMENT PANEL AIRBAG ASSEMBLY

   Click here

10. INSPECT AND ADJUST BRAKE PEDAL

    Click here

11. PERFORM INITIALIZATION AND CALIBRATION OF LINEAR SOLENOID VALVE

    Click here