PARKING BRAKE PEDAL(for RHD) REMOVAL

PROCEDURE


  1. REMOVE DRIVER SIDE KNEE AIRBAG ASSEMBLY

    Tech Tips

    This is symmetrical to the LHD model Click here.

  2. REMOVE REAR CONSOLE BOX ASSEMBLY

    Tech Tips

    This is symmetrical to the LHD model Click here.

  3. REMOVE SHIFT LEVER KNOB SUB-ASSEMBLY

    Tech Tips

    Perform the same procedure as for the LHD model Click here.

  4. REMOVE INTEGRATION CONTROL AND PANEL ASSEMBLY

    Tech Tips

    This is symmetrical to the LHD model Click here.

  5. REMOVE CONSOLE BOX INSERT

    Tech Tips

    This is symmetrical to the LHD model Click here.

  6. REMOVE CONSOLE BOX RH

    Tech Tips

    This is symmetrical to the LHD model Click here.

  7. REMOVE FRONT NO. 2 CONSOLE BOX INSERT

    Tech Tips

    This is symmetrical to the LHD model Click here.

  8. REMOVE CONSOLE BOX LH

    Tech Tips

    This is symmetrical to the LHD model Click here.

  9. REMOVE NO. 3 CONSOLE BOX MOUNTING BRACKET

    Tech Tips

    This is symmetrical to the LHD model Click here.

  10. REMOVE NO. 1 CONSOLE BOX MOUNTING BRACKET

    Tech Tips

    This is symmetrical to the LHD model Click here.

  11. REMOVE NO. 1 ELECTRICAL KEY OSCILLATOR

    Tech Tips

    This is symmetrical to the LHD model Click here.

  12. REMOVE NO. 2 CONSOLE BOX MOUNTING BRACKET


    1. B001LUD

      Disengage the clamp.

    2. Remove the 2 bolts and No. 2 console box mounting bracket.

  13. REMOVE YAW RATE AND ACCELERATION SENSOR

    Click here

  14. REMOVE FRONT FLOOR CENTER REINFORCEMENT


    1. B001KGB

      Remove the 4 bolts and front floor center reinforcement.

  15. REMOVE NO. 2 AIR DUCT SUB-ASSEMBLY

    Click here

  16. LOOSEN ADJUSTING NUT


    1. B001L2SE02
      Text in Illustration
      *1 Lock Nut
      *2 Adjusting Nut

      Remove the lock nut and loosen the adjusting nut.

  17. SEPARATE NO. 1 PARKING BRAKE PULL ROD SUB-ASSEMBLY


    1. B001N6IE01
      Text in Illustration
      *a Turn
      *b Hold

      Separate the No. 1 parking brake pull rod sub-assembly from the parking brake control pedal assembly as shown in the illustration.

  18. REMOVE PARKING BRAKE CONTROL PEDAL ASSEMBLY


    1. B001L0Z

      Remove the 5 bolts and separate the No. 1 parking brake cable assembly.

    2. Disengage the cable from the clamp.

    3. B001NEL

      Disconnect the parking brake switch connector.

    4. Disengage the wire harness clamp.

    5. B001LWT

      Remove the 2 bolts, nut and parking brake control pedal assembly.