STEERING ANGLE SENSOR REMOVAL

CAUTION / NOTICE / HINT

Note


  • Do not remove the steering angle sensor from the spiral cable.

  • While the auxiliary battery is connected, even if the power switch is off, the brake control system activates when the brake pedal is depressed or any door courtesy switch is turned on. Therefore, when servicing brake system components, do not depress the brake pedal or open/close the doors while the auxiliary battery is connected.

PROCEDURE


  1. REMOVE STEERING WHEEL ASSEMBLY

    Click here

  2. REMOVE STEERING COLUMN COVER

    Click here

  3. REMOVE SPIRAL CABLE WITH SENSOR SUB-ASSEMBLY


    1. Remove the spiral cable with sensor sub-assembly Click here.

      Note


      • Do not replace the spiral cable with sensor sub-assembly with the auxiliary battery connected and the power switch on (IG).

      • Do not rotate the spiral cable with sensor sub-assembly without the steering wheel with the auxiliary battery connected and the power switch on (IG).

      • Ensure that the steering wheel is installed and aligned straight when inspecting the steering angle sensor.

      • Do not remove the steering angle sensor from the spiral cable.