YAW RATE AND ACCELERATION SENSOR REMOVAL

CAUTION / NOTICE / HINT

Note

While the auxiliary battery is connected, even if the power switch is off, the brake control system activates when the brake pedal is depressed or any door courtesy switch is turned on. Therefore, when servicing brake system components, do not depress the brake pedal or open/close the doors while the auxiliary battery is connected.

PROCEDURE


  1. PRECAUTION

    Note

    After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal, Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work Click here.

  2. DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL


  3. REMOVE REAR CONSOLE BOX ASSEMBLY

    Click here

  4. REMOVE SHIFT LEVER KNOB SUB-ASSEMBLY

    Click here

  5. REMOVE INTEGRATION CONTROL AND PANEL ASSEMBLY

    Click here

  6. REMOVE CONSOLE BOX INSERT

    Click here

  7. REMOVE CONSOLE BOX LH

    Click here

  8. REMOVE YAW RATE AND ACCELERATION SENSOR


    1. B001M1U

      Remove the 2 bolts and yaw rate and acceleration sensor.

    2. Disconnect the connector from the yaw rate and acceleration sensor.