FRONT DOOR WINDOW FRAME MOULDING INSTALLATION

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedures for the RH side and LH side.

  • The procedures listed below are for the LH side.

PROCEDURE


  1. INSTALL FRONT DOOR WINDOW FRONT FRAME MOULDING LH


    1. Attach the clip to install the window frame moulding.

    2. Install a nose piece to an air riveter or hand riveter. Then insert the mandrel part of a new φ4 mm waterproof rivet into the nose piece.

    3. Using the air riveter or hand riveter, install the 6 rivets shown in the illustration.

      Tech Tips


      • Using the air riveter or hand riveter, install the 6 rivets shown in the illustration.

        Rivet Rivet Type
        (A) Short Type or Long Type
        (B) Long Type

      • If the rivet cannot be cut, pull it once and cut it.

      A001ACPE07
      *1 Rivet (A)
      *2 Rivet (B)

      Note


      • A001FDYE56
        *1 INCORRECT
        *2 Riveter
        *3 Mandrel
        *4 CORRECT

        Do not pry the rivet with the riveter, as this will cause damage to the riveter and mandrel.

      • A001C4EE35
        *1 Riveter
        *2 INCORRECT
        *3 CORRECT

        Confirm that the rivets are seated properly against the moulding.

      • Do not tilt the riveter when installing the rivet to the moulding.

      • Do not leave any space between the rivet head and moulding.

      • A001C08E32
        *1 Riveter
        *2 INCORRECT
        *3 CORRECT

        Do not leave any space between the moulding and door frame. Firmly hold together the 2 items while installing the rivet.

  2. INSTALL FRONT DOOR WEATHERSTRIP LH


    1. Clean the front door surface.


      1. Remove the double-sided tape from the front door.

      2. Wipe off any tape adhesive residue with cleaner.

    2. Install a new front door weatherstrip.


      1. Remove the peeling paper from the face of the front door weatherstrip.

        Tech Tips

        After removing the peeling paper, keep the exposed adhesive free from foreign matter.

      2. A001AZIE14
        *1 Front Door Weatherstrip
        *2 Double-sided Tape
        *3 Front Door No. 3 Weatherstrip

        Install the front door weatherstrip with the clip.

        Tech Tips

        Lift up the front door No. 3 weather strip to install the front door weatherstrip, as the front door weatherstrip affixes to the inner side of the front door No. 3 weatherstrip.

  3. INSTALL FRONT DOOR BELT MOULDING REAR END COVER LH

    Click here

  4. INSTALL DOOR FRAME GARNISH LH

    Click here

  5. INSTALL FRONT DOOR TRIM COVER LH

    Click here

  6. INSTALL FRONT DOOR TRIM BOARD SUB-ASSEMBLY LH

    Click here

  7. INSTALL POWER WINDOW REGULATOR MASTER SWITCH ASSEMBLY WITH FRONT DOOR ARMREST BASE PANEL

    Click here

  8. INSTALL FRONT DOOR INSIDE HANDLE BEZEL PLUG LH

    Click here