POWER SEAT SWITCH(w/ Shoulder Switch) INSPECTION

PROCEDURE


  1. INSPECT POWER SEAT SWITCH ASSEMBLY


    1. Check the resistance.

      A001EGHE01

      1. Measure the resistance according to the value(s) in the table below.

        Standard Resistance
        Tester Connection Switch Condition Specified Condition
        4 (HRFS) - 3 (E)

        Reclining switch (FRONT) on

        (Pushed)

        		 Below 1 Ω
        5 (HRRS) - 3 (E)

        Reclining switch (REAR) on

        (Pushed)

        		 Below 1 Ω

        4 (HRFS) - 3 (E)

        5 (HRRS) - 3 (E)

        Reclining switch off

        (Not Pushed)

        		 10 kΩ or higher
        2 (SLDF) - 3 (E)

        Slide switch (FRONT) on

        (Pushed)

        		 Below 1 Ω
        1 (SLDR) - 3 (E)

        Slide switch (REAR) on

        (Pushed)

        		 Below 1 Ω

        1 (SLDR) - 3 (E)

        2 (SLDF) - 3 (E)

        Slide switch off

        (Not Pushed)

        		 10 kΩ or higher

        If the result is not as specified, replace the power seat switch assembly.

        Text in Illustration
        *1 Reclining Switch
        *2 Slide Switch
        *a

        Component without harness connected

        (Power Seat Switch Assembly)