INNER REAR VIEW MIRROR INSTALLATION

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for RHD and LHD vehicles.

  • The procedure listed below is for LHD vehicles.

PROCEDURE


  1. INSTALL INNER REAR VIEW MIRROR ASSEMBLY (w/o Automatic High Beam System, Adaptive High Beam System)

    A001E7I

    1. Using a T20 "TORX" socket wrench, install the inner rear view mirror with the screw.

      Torque:
      1.8 N*m  { 18 kgf*cm, 16 in.*lbf }

    2. Connect the connector.

  2. INSTALL INNER REAR VIEW MIRROR ASSEMBLY (w/ Automatic High Beam System, Adaptive High Beam System)

    A001BIA

    Note


    • Do not touch the camera lens (built into the inner rear view mirror assembly) with a bare hand.

    • Do not allow anything to adhere to the camera lens (built into the inner rear view mirror assembly).

    • Do not apply strong impacts to the inner rear view mirror assembly.

    • Do not allow any liquid to get on the inner rear view mirror assembly.


    1. Using a T20 "TORX" socket wrench, install the inner rear view mirror with the screw.

      Torque:
      1.5 N*m  { 15 kgf*cm, 13 in.*lbf }

    2. Connect the connector.

  3. INSTALL RAIN SENSOR COVER (w/ Lane-keeping Assist System)

    Note

    When removing and installing the rain sensor cover, do not apply force to the object recognition camera areas labeled "X".

    A001DTKE01
    Text in Illustration
    *1 Clip
    *2 Camera

    1. A001B5LE04

      While being careful not to apply force to the camera area, attach the 2 claws and 2 clips to install the rain sensor cover.

    2. Push the stopper as shown in the illustration to fix the cover in place.

      Text in Illustration
      *1 Stopper

  4. INSTALL RAIN SENSOR COVER (w/o Lane-keeping Assist System)


    1. A001C6OE02
      *1 Stopper

      Attach the 2 claws to install the rain sensor cover.

    2. Push the stopper as shown in the illustration to fix the cover in place.

  5. INSTALL MAP LIGHT ASSEMBLY

    Click here

  6. ADJUST ADAPTIVE HIGH BEAM CAMERA BEAM AXIS

    Click here