INNER REAR VIEW MIRROR REMOVAL

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for RHD and LHD vehicles.

  • The procedure listed below is for LHD vehicles.

PROCEDURE


  1. REMOVE MAP LIGHT ASSEMBLY

    Click here

  2. REMOVE RAIN SENSOR COVER (w/o Lane-keeping Assist System)

    A001A8ME02
    *1 Stopper

    1. Pull the stopper in the direction shown in the illustration.

    2. Detach the 2 claws and remove the rain sensor cover.

  3. REMOVE RAIN SENSOR COVER (w/ Lane-keeping Assist System)

    Note

    When removing and installing the rain sensor cover, do not apply force to the object recognition camera areas labeled "X".

    A001DTKE03
    *1 Camera
    *2 Clip

    1. Pull the stopper in the direction shown in the illustration.

      A001EL2E03
      *1 Stopper

    2. While being careful not to apply force to the camera area, detach the 2 clips and 2 claws and remove the rain sensor cover.

  4. REMOVE INNER REAR VIEW MIRROR ASSEMBLY (w/o Automatic High Beam System, Adaptive High Beam System)


    1. Disconnect the connector.

    2. A001E7I

      Using a T20 "TORX" socket wrench, remove the screw and the inner rear view mirror.

  5. REMOVE INNER REAR VIEW MIRROR ASSEMBLY (w/ Automatic High Beam System, Adaptive High Beam System)

    Note


    • Do not touch the camera lens (built into the inner rear view mirror assembly) with a bare hand.

    • Do not allow anything to adhere to the camera lens (built into the inner rear view mirror assembly).

    • Do not apply strong impacts to the inner rear view mirror assembly.

    • Do not allow any liquids to get on the inner rear view mirror assembly.


    1. Disconnect the connector.

    2. A001BIA

      Using a T20 "TORX" socket wrench, remove the screw and inner rear view mirror.